-
As described in other issues, I am having trouble getting the BTT Microprobe to work with the Pico. I have everything wired up correctly using the servos and probe ports on the board, have removed the…
-
I would like to hack this device so I can access the TF card readers SPI lines for the SKR PRO and SKR GTR boards. That way I can hook up a PT100 sensor via the SPI1 bus. I need the schematic for th…
-
I have a dual z axis ender 3 pro with CR Touch. My setup was working fine before the upgrade to the new mainboard that was purchased for the dual z axis. Whenever I try to home after the install it …
-
Hello,
i search a new clean Linux Image for the MKS Pi to use it at other DIY-Projekt's as a real alternate for an Raspberry Pi.
Image for Debian, Ubuntu or armbian that were really cool.
-
# Lines of code
https://github.com/code-423n4/2023-09-venus/blob/main/contracts/Tokens/Prime/PrimeLiquidityProvider.sol#L310-L326
# Vulnerability details
## Impact
In contract `PrimeLiquidityProvi…
-
I'm a bit puzzled...
on the doc https://github.com/bigtreetech/BIGTREETECH-S42B-V1.0/blob/master/42%20Stepper%20Motor%20Closed%20Loop%20Driver%20Control%20Board%20Manual.pdf, there is written that 2…
-
I am having an issue where i get "timer too close" at unloading sequence. Print is running fine for a couple of hours with many toolswaps and then suddenly i get this error, always at unloading. I'm r…
-
Would it be possible to change the firmware so the momentary switching of 5v and RST turns the relay off as well as on? I'm currently working on a 600x600x600 printer that had a board with a built in …
-
I am having install/boot issues with my adxl345 on my Manta M8P +CB1 V1.0
I am unable to boot with the ADXL345 sensor attached to SPI1. Interestingly enough, if I hot plug the sensor into the SPI …
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Using TMC2209 drivers on an Octopus motherboard with a full graphics smart controller. …