-
First of all I hope I can ask overhere for help.
I'm trying to add a nice vintage, zigbee certified, led light from the manufacturer GMY.
www.gmysmart.com but i'm getting an error. I'm using a 2531C…
-
Thermal Runaway Not Caught
I would advise against trying to reproduce this- install a 12V heater cartridge powered by 24V controlled via a mosfet with trigger wires on RAMPS D8 pin. Failure of the …
-
#### What were you doing?
I opened web interface to check webcam feed like I always do in my phone (android, firefox) without problem.
The printer was printing for about 5 hours.
#### What did…
-
### Description
Printer increases temperature to 325C on the second layer when it is set at 235C
This occurs on the latest stable branch downloaded 2018-08-24
This happened to me first on the ini…
-
Hi guys,
Firstly I love this project, I've made a few of these now and they are super handy. Keep it up!
I've run into an issue that I ignored at first, but have since decided I should find a so…
-
Hello!
I am trying to change the filament using the M600 command without an LCD screen and an encoder. The way I want to do it, is calling other M commands when the printer asks for input.
I hav…
-
By monitoring more than one energy meter at home it would be possible to keep consumption from the Car and the Heating system on separate "tabs". I imagine that the code change would be rather small, …
-
There is only one picture "On Z Change" in Timelapse.
-
#### What were you doing?
I designed a model using GCode, uploaded it in OctoPrint, and waited for OctoPrint to finish analyzing it. I then pressed the Print button.
#### What did you expect to happe…
-
Provide a description on how to connect the BME 280 to the ESP