-
```
A) What steps will reproduce the problem?
1. Create a new Spin project (or open an old one)
2. Compile project (compile works!)
3. Try to load the project to the EEPROM or to RAM
B) What i…
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
Hey guys, someone in the forum posted some feedback concerning our FDM, see:
> I love what you've accomplished with the c172p!
>
> I have one little gripe though...To me it doesn't seem like p-facto…
-
Hi.
I have a serious problem after upgrading from cleanflight v1.12 to cleanflight v1.13.0 out of the master tree. I flew with the default settings after firmware settings reset. All went ok, but afte…
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…
-
I've built and installed the latest Propeller IDE form source on Raspbian Jessie, and seem to have some trouble with downloading code to Propeller HAT which requires a GPIO reset asserted on Pin 17.
…
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…
-
```
What steps will reproduce the problem?
1.Fresh load of 4.3 Beta
2.reboot
3.copy/paste fs.f
--------------
decimal \ last line of fs.f copy/paste
Prop0 Cog0 ok
Prop0 Cog0 ok
Prop0 Cog0 o…
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…