-
I built the nightlies on my ODROID XU, which is an ARMv7 device. But, I don't know if the produced binaries are generic enough (i.e. if they don't contain ARMv7 specific instructions) to run on the RP…
-
hi, thanks for sharing your code.
trying to install Piautomator in my Rpi and i followed all the steps but i get this error:
pi@raspberrypi /home/PiAutomator $ sudo ./bin/start-automator.sh
/opt/h…
-
Hi Stockmopar,
I just tried to play around with your nodejs implementation of ConnectedByTCP but no luck. I tried on OSX with node 0.10.21 and I try on a raspbian with node 0.10.24 and I get the same…
-
Hello Altogether,
I have setup a WeatherBinding which works fine.
Then I added the my.openhab binding/service for remote access.
My problem no is that only one of the two services is running:
Weath…
-
Hi,
I'm building a small network of sensors in my apartment around a RS485 bus. The sensors are Arduino Pro Micro and the master is a Raspberry Pi.
Your rs485switch.c solution is what I need for cont…
-
I just installed on my RPi and is really nice and neat! Congratulations!
As a first job I would like to port my other installation to pimatic and I would like some first hints to start.
I need to crea…
-
Sadly I missed the crowdfunding of the Raspberry port. I used the following tutorial to get kivy on the raspberry running:
http://wonderfulcode.tumblr.com/post/54102854344/kivy-on-raspberry-pi
I have…
-
After hours of patience I finally got this working, yes there's plenty of thing to be added or enhanced, however heimcontrol.js is the most advanced home automation raspberryPI project I have been pla…
-
Hi, I have skynet.im and also skynet hub installed on my raspberry pi. Having a little difficulty on how to get my home automation talking to each other.
I have a usb tellstick attached to the Pi and…
-
Hello,
i am totally new with the Java "Thing" and you would help me a lot when you can liste the 2-3 positions i must change for me.
I found that in the
app/partials/switches.html
i change the swi…