-
Hello,
I have problems getting the readings to my SDM120C Modbus meter running. I don´t know, if this is a bug or if I am lacking information, or if my setup is wrong.
I tried to fill out the ch…
D-t-M updated
5 years ago
-
Attempting to compile gives this error message:
```
Arduino: 1.8.8 (Windows Store 1.8.19.0) (Windows 10), Board: "LOLIN(WEMOS) D1 R2 & mini, 80 MHz, Flash, Enabled, 4M (no SPIFFS), v2 Lower Memory…
-
Hi, I hope you'll can help me. I'm working now with MH ET Live mini and some Wemos D1 mini' shields. I don't know about electronics and currently I'm learning to use these amazing devices.
In my pr…
-
I have had McLighting working great with a couple of ESP8266-01 modules. I have 3 new Wemos D1 Mini's and figured it would be a pretty easy switch over.
Unfortunately, I can install the software, …
-
Hi,
I have ESP32-Nodemcu Lolin v3 board and RFM95 module. I chose the _PIN_OUT==3 connected the same pins for Wemos here in nodemcu, but it does not work.
I get this error:
> Unknown transcei…
-
I have the same problem on two different systems. Everything works but I'm getting constant random flashes while sending colour information. It doesn't flash while sending random colours. Rebooting d…
-
Hi guys.
I've worked 2 days ago to flash my esp Over The Air.
Uploaded BasicOTA official sketch, All things went fine. Tested file uploading with success.
Today I went to develop the code and mer…
-
Hallo, dein Climate Display ist echt spitze. Ich habe aber ein Problem mit verschobener Darstellung, was nach etwas googlei wohl an dem Adafruit_SSD1306 und deren fehlende Unterstützung für das 64x48 …
-
Hello everyone, I have a problem when loading the sketch.
I have the following error message and ej can not find help on this:
_"Arduino : 1.8.6 (Windows Store 1.8.14.0) (Windows 10), Carte : "L…
-
Wemos D1 mini IR controller shield specifications:
- **4x IR LEDs** (940nm) pointing in four different directions
- 1x IR receiver (38 kHz) for learning function
- Tx/Rx mode selection – Sender –…