-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
I believe we urgently need to update the [wiki page of the c172p](http://wiki.flightgear.org/Cessna_172P) with the list of new features of our plane, as well as some basic explanations that new users …
-
```
What steps will reproduce the problem?
1. Boot Arduino
2. Log pages are iterated
3. Select 3 to exit logmode
4. Code waits for slider to be switched which does not exist on the
non-shielded mega.…
-
```
For safety on ground it is paramount to know whether the motor controls are
armed or not armed. As per default it is only signalled on the APM board on a
little, in many installations partly hid…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
Rather than the standard "steps to repro, expected output, etc.", this bug
report will just "dive in" to details...
Problems occur when using the feature documented in the Propeller GCC Library …
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…
-
by tigert:
> The propeller tip stripe and the sticker in the propeller, at least in the OH-CTL livery, only appear in the front side of the blades. The backside is black, to avoid flickering and glar…
-
```
I think it would be neat with all propellers in the same level spinning the
same direction. That gives some obvious advantages:
Less (and also more stringent) "Y6 yaw issue", because the differe…