-
Hi,
I want to adapt library to work in Single-channel gateway mode. It is necessary to collect a cheap gateway based on SX127X modules for testing and debugging. Is it even possible to do this on t…
-
Hi,
I would like to enable the PA_Boost to have +20dBm in the radio output with 915MHz frequency band:
I think we need to play with 3 registers:
**paConfig =0xFF**
_PaSelect_(7) =1 -->Pa_Boo…
-
Dear Pham!
Thank you for all your efforts to share your experiences with LoRa technology.
Using the provided documentation and software I managed to create a working setup on 868MHz with a RPI3+[c…
-
I have a Cypress USB-UART that has the SX1272 chipset. Looking to use this on my Windows 7 Pro 64-bit laptop. As a receiver, since the transmitter is an Arduino Uno with a Dragino Lora GPS shield on t…
-
Hi
The library support chip SX1231 or RFM69HCW?
Thanks
-
This is the error received when attempting to run test_lora.py
I'm using a raspberry pi zero, and have the pins as described, with 3v3 -> 3.3v, all the GNDs going to separate GNDs on the Pi, SCLK -> …
-
Power
"The SX127x transceivers need a supply voltage between 1.8V and 3.9V. Using a 3.3V supply is typical. The SX127x chips have various supply lines (VR_ANA, VR_DIG and VR_PA), all of which need th…
-
Hi,
I am receiving the following after following the 'Installation' section and running 'sudo ./lora_util.py'
> /home/pi/projects/pySX127x/SX127x/board_config.py:51: RuntimeWarning: This channel is …
-
Below is the implementation of SetOpMode, static variable opModePrev is used to keep previous mode, but this value is not always synced with the acctual mode, like situation user transmits one packet,…
-
I have a SX127x module (http://modtronix.com/inair9B.html) and trying to connect to the lorawan network.
what parts of the lorawan communication is handled by this module? In the LoRaWan specificati…