-
To add information about a recording device, e.g. who was the manufacturer, what kind of amplifier, what version is it, what settings were used (or analogous information about an imaging microscope), …
-
The YANG model for OI has been updated to allow profiling the YANG model for other applications besides the original OI applications
However, in order to foster interoperability, there is a need to…
-
At the moment it can be quite hard to see the Reinforced Reduced amplifier, so it should be made bigger.
-
A typical amplifier will have an integrated Variable Optical Attenuator integrated. So I suggest to add voa target value and actual voa attenuation into optical-amplifier.yang config and state contain…
-
I am using a small 3 watt amplifier chip to amplify the RDA5807 output to speaker level. I have found that the RDA5807 overdrives the input (only usable volume is one). I added a 10uf decoupling cap…
-
Hi,
I installed tidal-connect by your script on a Raspberry Pi 4 with Moode, connected to an integrated amplifier (Mission 778X) by USB .
Using Tidal app from my iphone, I read "MQA" under title of …
-
Hello, I set it according to realtek's method, but only in the case of a loud volume of my speaker, the voice will be recognized and translated, and the loud volume will affect the viewing, how can I …
-
**What kind of device or service you would like to see an adapter for?**
For multiroom-amplifier MCA-C5 and others from the manufacturer Russound wich can be controlled via the "RIO"-protocol.
(http…
-
Hi again,
as I continued with my experiments I needed to test if some materials will block RF and how much.
In material datasheet I have found that they are using two probes for test, so I have…
-
The DECam S30 amplifier (which one?) is unstable, leading to both discontinuities in the sky+fringe correction, but also photometric offsets. This is a ~0.7% effect. The CP fits out the discontinuit…