-
```
What steps will reproduce the problem?
1. Install recent Arduino IDE (mentioned in summary)
2. Install arduino-tiny as described in readme.txt of arduino-tiny
3. Create boards.txt from proposed bo…
-
```
What steps will reproduce the problem?
1. Install recent Arduino IDE (mentioned in summary)
2. Install arduino-tiny as described in readme.txt of arduino-tiny
3. Create boards.txt from proposed bo…
-
```
What steps will reproduce the problem?
1. Install recent Arduino IDE (mentioned in summary)
2. Install arduino-tiny as described in readme.txt of arduino-tiny
3. Create boards.txt from proposed bo…
-
```
What steps will reproduce the problem?
1. Install recent Arduino IDE (mentioned in summary)
2. Install arduino-tiny as described in readme.txt of arduino-tiny
3. Create boards.txt from proposed bo…
-
```
What steps will reproduce the problem?
1. Install recent Arduino IDE (mentioned in summary)
2. Install arduino-tiny as described in readme.txt of arduino-tiny
3. Create boards.txt from proposed bo…
-
```
What steps will reproduce the problem?
1. Install recent Arduino IDE (mentioned in summary)
2. Install arduino-tiny as described in readme.txt of arduino-tiny
3. Create boards.txt from proposed bo…
-
```
What steps will reproduce the problem?
1. Install recent Arduino IDE (mentioned in summary)
2. Install arduino-tiny as described in readme.txt of arduino-tiny
3. Create boards.txt from proposed bo…
-
Add new board definitions based on [this gist](https://gist.github.com/ah01/762576)
```c++
#if defined(__AVR_ATmega168__)
// Arduino Diecimila and older
LINE("__AVR_ATmega168__", __AVR…
-
When I ran setup.py it said MCUs 0 and there is only one MCU to choose from when starting an new project.
-
Most of the ATmega/ATtiny symbols end their descriptions and use footprints starting with "QFN-xx" where they should perhaps be more specific, eg. "VQFN". The problem: Atmel could not seem to decide w…