-
```
What steps will reproduce the problem?
1. configure device001/2 with ATmega128; 16MHz; Large
The following output will be displayed
Calculate code size: device_001.sizeelf
avr-gcc -mmcu=atmega1…
-
```
What steps will reproduce the problem?
1. configure device001/2 with ATmega128; 16MHz; Large
The following output will be displayed
Calculate code size: device_001.sizeelf
avr-gcc -mmcu=atmega1…
-
When I ran setup.py it said MCUs 0 and there is only one MCU to choose from when starting an new project.
-
Most of the ATmega/ATtiny symbols end their descriptions and use footprints starting with "QFN-xx" where they should perhaps be more specific, eg. "VQFN". The problem: Atmel could not seem to decide w…
-
The list of chips that are nominally supposed to be supported by Optiboot seems to be growing quite long; much larger than I'm able to test myself.
I'd like to build a network of people who are willi…
-
```
What steps will reproduce the problem?
1. Attempt to use PinChangeInt with an Arduino Mega.
I have not attempted to do this yet, but am considering my board options for a
current project. How m…
-
### Describe the problem
The Arduino language features are not available after startup.
### To reproduce
- Have no attached boards,
- Start IDE2,
- Select `Arduino Uno` board (can be any),…
-
```
What steps will reproduce the problem?
1. Attempt to use PinChangeInt with an Arduino Mega.
I have not attempted to do this yet, but am considering my board options for a
current project. How m…
-
```
What steps will reproduce the problem?
1. Attempt to use PinChangeInt with an Arduino Mega.
I have not attempted to do this yet, but am considering my board options for a
current project. How m…
-
```
What steps will reproduce the problem?
1. Attempt to use PinChangeInt with an Arduino Mega.
I have not attempted to do this yet, but am considering my board options for a
current project. How m…