-
### Bug Description
It currently doesn't seem as if the various bed levelling options (although to be honest I've only been able to test auto bi-linear) don't work when your Z-moves are below the…
-
### mpv Information
```bash
mpv v0.39.0-170-g37159a8ee0 Copyright © 2000-2024 mpv/MPlayer/mplayer2 projects
built on Oct 20 2024 00:54:23
libplacebo version: v7.349.0 (v7.349.0-18-g9e16c86f)
FFmp…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Using TMC2209 drivers on an Octopus motherboard with a full graphics smart controller. …
-
### Description
When using latest compiled firmware:
https://github.com/bigtreetech/BIGTREETECH-SKR-mini-E3/blob/master/firmware/V1.2/firmware-bltouch-for-z-homing.bin
and using a v1.2 board th…
-
While trying to split a rear tail section of an RC airplane, I used BS hoping it would be a quick, easy solution to the previous issue, which was that the Z axis wanted to dip below the build plate to…
-
My z-probe is offset 30,10,5mm - so it's above the nozzle.
So I use 3-point auto leveling and use 3 spots where the nozzle is outside the bed, but the zprobe is not.
I have defined my "Z-probe-heigh…
-
Using M25 during Cura Start Gcode crashes the printer
the purpose i was using the M25 command was to first present the bed out and then pause the printing process right before the print actually b…
-
Hello,
When leveling the bed with BLtouch original using 4.4.0 firmware, it only probes the first 6 points and "forgets" the last 3 ones. It was working fine with 3.3.9 firmware. I've tried both …
-
### Description
I just flashed my XY-3 Pro. Because there wasn't a prewrote "#define" for my printer I had to get creative In config.h I used the
XY-3_V5_330_NO_TITAN_TMC_NO_ABL
I changed the fo…
-
Hi all,
I'm new with Marlin, just upgraded from the TronXY Firmware to Marlin.
I have a TronXY X5SA with the following parameter V6_330_TITAN_TMC 1
I use the following GitHub [[github.com](https://…