-
Hi There,
I usually create custom boards for Arduino IDE that I place in `hardware\` folder and then I can select these board from IDE and compile + upload. In this case I never need to download to m…
-
### Is your feature request related to a problem?
It would be nice to have an example of how to turn on tx interrupts for the uart, register a tx interrupt handler, and to determine when there is s…
-
I'm trying to use an Arduino micro as Bootkeyboard to control a KVM Switch. It seems the Keyboard is not recognized at all.
Are there different modes i could try?
The KVM support a Hotkey which is…
-
Hello, goodafternoom!
When compiling the example of the infrared remote, the following error appears: Arduino: 1.6.8 (Windows 7) Sign: "Arduino / Genuino Uno"
C: \ Program Files \ Arduino \ arduino-b…
-
Hello,
I wanted to ask whether it is possible to use the SoftwareSerial library in tinylab? Most of the pins are occupied, so I couldn't managed to use the library. I hope you have an advice.
M…
-
- [x] Design and Publish Schematics and EasyEDA link
- [ ] Add DIN Rail Mount for the PCB
- [x] Add Gerber files
- [x] Add Files for PCB Assembly
-
I'm not sure how specific it is to the SAMD11 implementation so apologies if this is the wrong place to report/ask about this but I currently face the issue that a lot of code compiles to a much small…
-
Basically, many errors with attempted redefine...
```
Arduino: 1.8.16 (Linux), Board: "Generic STM32F1 series, BluePill F103C8, STM32CubeProgrammer (SWD), Enabled (generic 'Serial'), CDC (generic …
AndKe updated
2 years ago
-
I am trying to communicate with a CDC mode USB device that is sending and receiving serial data. The SetLineCoding function hasn't been working for me so I cannot set it into the right mode, unless I …
-
Hello,
I setup chinese Nano 3.0 board with esp-link controller and everything works like charm. Then i tried to replace Nano with chinese 'micro' boards on 32u4 chip and none of them is accept firmwa…