-
Hi, I have a 3.5 inch screen that plugs into the GPIO pins, I have installed the relevant drivers via terminal but whilst the screen lights up I get nothing displaying the screen. Is this feature poss…
-
So I wrote the CB1 image.
In the system.cfg file I put in my Wifi info. I did the 2.4ghz since not sure if 5 supported. I am looking for IP and not finding it on network. On the Manta board there i…
-
I've got reprap firmware loaded on an SKR-2 and connect to it via YAT no problem. When I try to upload wifi firmware to the ESP module(s), I either get an failure to connect error at different baud ra…
-
Connecting an ADXL345 to SPI1 on my Manta M8P causes the MCU to not boot. It seems like the bootloader is conflicting with some other device on SPI1 on boot.
Can anyone confirm if there is any othe…
-
GPL requires sources necessary to fully rebuild a binary release be published as part of the release. The "source" tarballs on the release page are just a copy of this repository with no source, link…
-
Moonraker is currently not able to access the gpio pins.
[gpio.py:_request_gpio()] - Unable to init gpiochip0:gpio6. Make sure the gpio is not in use by another program or exported by sysfs.
Traceb…
-
Then and after a meticulous installation for the cables, the tightenings, the leveling even manual and finally the park Bed&Mesh and the Z-Offset in order to have the perfect configuration I tried to …
-
Hello, can anyone please upload the V2 bootloader, I think my board has a dmaged bootloader/ mcu, I just got three days ago without having the chance to use it till now,
I'm trying to flash the firm…
-
Manta M8P with HermitCrap V1 was working fine with microprobe V1.2. After the pin get damaged and replaced with microprobe V2 it keeps given the some error, "Endstop z still triggered after retract" t…
-
I tried to run 3.5 inch LCD with driver ili9488 in 4-line SPI mode on fbtft overlay, but this driver (ili9488) does not support RGB565 mode in 4 line SPI. If driver init with RGB666, then i`m take wro…