-
Hi,
is it possible to add support for an Inkbird ITH-20R for esp32 with cc1101 i am not sure how to add additional decoders. a link for it working with rlt_433 is , https://github.com/ehagan/rtl_4…
-
**Describe the bug**
The MQTT settings are restored to default values when the module restarts. This happens when restarting the device from the web page but also when the cable between the Itho WPU …
-
One need first define the settings and only after that try getCC1101(), not the other way around. Examples does not work because they have it the wrong way around around.
Correct way:
```
void…
frspp updated
9 months ago
-
**Hi.** I have some ideas for improving the project that you might like.:
1) **NRF24L01**
It would be nice to add a detailed connection diagram NRF24L01 for M5stack Plus 2 and 1 in README.md
Since …
-
Calling `ELECHOUSE_CC1101::setGDO(byte gdo0, byte gdo2)` causes the library to not work correctly.
This is because it calls `ELECHOUSE_CC1101::GDO_Set` which sets `pinMode(GDO0, OUTPUT);`. It should …
-
## Expected Behavior
In der Beschreibung des genannten SET Befehls fehlt ein Hinweis, dass die Freuqenz des Sendens beim Senden unabhängig von dieser Einstellung verändert werden kann und dies bei …
-
I am having troubles with wiring I believe
Stuck in boot loop
Due to the dual spi configs
I can not even boot when I have rx and d4 (I have code chip select for both cc1101 and tft on gpio 15 (D8) …
-
Was wird im Moment verwendet CC1101 oder CC1110 ?
Die Bilder im Internet lassen das nicht klar erkennen, www.ciseco.co.uk und openmicro.com scheinen nicht mehr zu existieren, einzig docs.ciseco.co.uk…
-
Is there possibilty to change IO TX pin in esphome config when using other module or use other pins of esp32 module?
-
Hi,
like your project so far. Could you add a library.properties file? Otherwise energia (ver. 1.6.10E18) does not correctly recognize your lib.
Example:
name=CC1101
version=1.0.0
author=jhes…