-
I am trying to load the bootloader to cc1352, if I erase completely with uniflash I can program the new firmware, but once with the new firmware I can't reload other firmware
Thanks
-
Why is there no checksum verification in the communication between slip-radio and 6lbr?
If the communication is over USB, then there shouldn't be any problem, but if it's over UART, then there will b…
-
In reference to an issue reported on sourceforge:
https://sourceforge.net/p/contiki/mailman/contiki-developers/thread/CAFBGMVOe5SPfnBr%2BrRMNAdkp3Hm%2BtmCFysv6AzixYs%2BYzHLR3g%40mail.gmail.com/#msg34…
-
I am currently starting to write my master thesis about BLE and IoT and use the TI SensorTag as the platform to do so. The result of my thesis should be [IPv6 over BLE](https://tools.ietf.org/html/dra…
-
The subscriber client script subscribe.py will occasionally reach time out and stop logging data without fatal error. This has been observed to be preceded by the LED on the CC2531 USB dongle going th…
-
I am trying to setup the 6Lowpan network with Beaglebone Black (Linux Debian) as edge router, CC2531 USB Dongle as SLIP Radio and two cc2650 flashed with cc26xx-web-demo as mesh nodes.
I am able to…
-
## Introduction
This is a proposal for a minimal subset of Devicetree bindings to allow for autoconfiguration of multiple network interfaces via `DT_INST_FOREACH_STATUS_OKAY()`.
The primary rea…
-
Hi,
I am planning to connect a sensor to my CC1310 via i2c port.
Which library should I use? I didn't find any that is specific to CC13xx.
The only one I found is board-i2c.h for sensortag. Can I…
-
Hi,
I have one rpl border router and a base station. The border router is running on raspberry pi. There exists also nodejs script which holds firmware binary of size of around 80KB, which has to b…
-
@RoaddogLabs
I'm going to order one of these (https://www.adafruit.com/product/3406) and wire it to the Chenbo LC amp. If you have any ideas hardware-wise to make this arrangement cheaper please po…