-
Following with instruction https://wiki.allstarlink.org/wiki/Compiling
**Install Linux Sources and Headers**:
apt-get install -y linux-headers-generic linux-source
**Build DAHDI**:
git clon…
-
**Describe the bug**
Cannot connect to EchoLink node and get the following error in the logs...
WARNING[1215][C-00000012] pbx.c: Channel 'echolink/el0-4' sent to invalid extension but no invalid han…
-
In letzter Zeit habe sich Funkamateure gemeldet die auf aprs.fi ausgeblendet werden moechten. Daher waere es gut wenn Sysops in den eigenen Sendereinstellungen die Kartendarstellung ein- und ausschalt…
-
This additional parameter is an absolute MUST HAVE item. A repeater continually identifying itself every 10 minutes 24/7 even when not being used is annoying, and considered downright rude in some ar…
-
Hi,
I'm using svxlink with GPIO for Tx and Rx. Svxlink version is master from github.
This is a correct behaviour when TIMEOUT is set to 10 seconds (I'm using 10 seconds for this report only, my…
-
Arnold (9V1CD) had reported of a problem with difficulty or problems triggering the repeater when output power was set to 25W. It is uncertain what might be causing this problem but it is possible tha…
-
I have a working Svxlink setup, version 17.12.2-4 running on a Raspberry Pi4
I've tried to add an SDR to improve receive range and no matter how I config I get terrible interference on the audio. S…
-
hello we run about 100 link in our network , password for individual link is not a good idea ...
whe use firewall for remove / accept them
please have a look at our dashboard of RRF http://rrf.f…
f5nlg updated
5 years ago
-
Please look into properly showing tlb private nodes. As you can see in the screenshot below, private node 1100 is a tlb connection and it doesn't properly show in either its own line, nor when it is c…
-
Bonjour, serait-il possible d'intégrer une page de connexion avec login et mdp afin de sécuriser l'accès depuis l'extérieur ?
73's qro.
f5swb/Dimitri.
f5swb updated
5 years ago