-
Hi Guys
Generally I use a manual 4 corner bed level on my 3d printers as I feel I can get a better level given my beds at 420 x 420mm are usually larger than the average printer. Also because I usu…
-
-
Hi
I installed a BL Touch (from Antclabs) and the Micro Swiss Direct Drive Extruder Setup. Now i need to change the #define X_MIN_POS and #define Y_MIN_POS to #define X_MIN_POS -5 and #define Y_MIN_P…
-
I have been toying with the idea for a few weeks now about unifying some of the communications with 3D printers. And thereby future proofing the 3D printer market.
One of these ideas, is looking a…
-
### Summary
G115 reports issues even if we do proper bounds checks. This is similar in spirit to #1185, but would require the linter to be smarter.
### Steps to reproduce the behavior
```go
…
-
Hello,
I'm exploring the dating option with my data using the input as follows:
\iqtree2.exe -s lemni_realligned_20200602_woalti.phy -p best_scheme_realligned_PF_20200602.txt -t PARS -B 5000 --date…
-
Hi!
I have a skr 1.3 Board using the Flash Magic program and installing the boot jumper, I was able to flash the bootloader into the Board.
There is also a scr 1.4 turbo Board , but there is no boot…
-
Is an ongoing issue that will happen at random after five hours. At first I thought it was a faulty VGA cord. Or maybe I just wanted to believe it was. I know it's not my hotend. The extruder causes t…
-
Hi,
just got my Octopus 1.1 and try to upload Marlin on it. But after connecting via usb board not detected by Windows (no new devices in Device Manager, any type), aslo not detected by STM32CubePro…
-
# ⚠️ P-L-E-A-S-E, PLEASE, PLEASE, PLEASE read and follow all of the instructions first ⚠️
### Note: After each step, close your current tabs and open new tab to test again or it won't work.
### If…