-
Hi, first off thanks for your hard work and very nice integration to myUplink!
I have a F1255-16 with the upgraded firmware to be compatible with myUplink instead of Nibe Uplink.
Everything look…
-
Hello and, firstly, congratulations and thanks for the work with this, it's really great!
I have a small issue with my controller only going to the next step after about a minute or so, which somet…
-
Hello,
I successfully built a KM bus to ethernet adapter using NCN5150 IC plus LPC1769 evaluation board.
I can now successfully transmit all the data received on KM bus to ethernet. I haven't test…
-
- If peak temperature is not reached, continue heating and pause progression in profile until it is (with a safety limit; e.g. must be reached in xx seconds).
- Let user select which sensor(s) should…
-
Great work on this, I managed to use it to pair to my 100ah lithium battery via the hub from my laptop. Great little starter kit to build a monitoring dashboard.
-
Recently I received a Bosch Supraeco STE 80-1 heatpump connected via the MB LAN 2 interface, but the Bosch EasyRemote-App is very limited to monitor the status of the heatpump. Have users been success…
-
I just had a closer look at your new code and I fully understand it now. This code is kind of similar to the code I initially created, but way shorter and easier.
cop_gw = seed_triangular(DISTRIBU…
-
Heute wurde ich von Viessmann per Mail informiert, dass die bisherige API zum 15.07.21 abgeschaltet wird. Bedeutet dies, dass dieser Adapter dann auch vorerst ohne Funktion sein wird?
Falls ja, wird …
-
I am currently working on a novel OSM-S-106 sulfamate analog based on a [previous OSM-S-106 synthetic routes](https://github.com/OpenSourceMalaria/Series3/wiki/Synthesis-of-the-Original-Hit) that inco…
-
In colder climates the printer (MK3) powers up and goes to error min bed temp. After heating the bed with a hot air gun it clears to hot end min temp and after a little heating so does the hot end. I…