-
Okay, I want to read more about proxmark3 rdv40 and make a decision wether it is worth buying or not.
First I go to rfidresearchgroup.com and what I see. It's an instagram with fashionable colourfu…
-
I noticed that the `hydrafw.dfu` file has no release set on the firmware file; this means that we can't notify the user if we try to downgrade the firmware:
```
dfu-tool dump hydrafw.dfu
Loading hyd…
-
* I want to use live sniffing but it's unhandy to connect simultaneously 2 usb cables in the same time. Is there any way to get live output via DFU USB port? Maybe with some lag. For now I'm connectin…
-
I have hydrabus with latest firmware builded from current git repo:
```
> show system
HydraFW (HydraBus) v0.8-beta-55-g2e933dc-dirty 2017-10-10
sysTime: 0x0022ce41.
cyclecounter: 0xec1f68fa cyc…
-
Hello,
I tried to use HydraFW with Sigrok according to the wiki article ( https://github.com/hydrabus/hydrafw/wiki/HydraFW-SUMP-guide ). However after entering SUMP mode PulseView doesn't find the …
-
Remarks related to STM32F777NIH6:
* Replace the MCU by an [STM32H750 Value Line ](https://www.st.com/en/microcontrollers/stm32h750-value-line.html?querycriteria=productId=LN2121) they are clearly ch…
-
I am using a generic nRF51 board. After programming, the sketch starts (e.g., the blink sketch) -- but only until I cut power to the device.
The sketch does not run after power cycling. In other wo…
-
It is not fixed again !! see Load and Save configuration #47
Are you doing some tests before closing issues ??
I have loaded this file:
http://hydrabus.com/HydraNFC_spi_ss_tests.dsl
Then I configure…
-
**_Reported by Andrew Boie:_**
We are going to need to debug low-level boot of ESP32. This board supports OpenOCD/flyswatter. See attached document. Enable the "make debugserver" target in the build …
-
What's the usage license of the HydraBus hardware?