-
On user manual there is a picture on how to connect this sensors with the board, i have actually hooked up one of this sensor.
But need some help / examples on how to use it from software / config si…
-
Well done!
I'm sat here trying to do my first Klipper installation on my bone stock SV01 Pro.
I've currently installed Mainsail OS from the Raspberry Pi OS imager, and flashed it onto my Raspberr…
-
### Is your feature request related to a problem? Please describe
Currently Fluidd seems to estimate print times in a very naive and inaccurate way based on percentage printed and the print times est…
-
![IMG_3024](https://github.com/QIDITECH/QIDI_Q1_Pro/assets/161778185/744753e7-0cae-4960-93b2-fb556d545e9d)
-
The current documentation for building the klipper firmware for the MCU on this board does not indicate values for the build options available in the current version of klipper. Could you please updat…
-
Trying to run sensorless and keep getting this error:
```
Receive: 91 342.421202 342.416261 18: seq: 14, tmcuart_response oid=8 read=b'\n\xfaO \x80\x00\x02(\xa3\xc6'
Receive: 92 342.426574 342.…
-
### Is your feature request related to a problem? Please describe.
Need to add support for Trigorilla V3.0.6
### Are you looking for hardware support?
Printer: Anycubic Kobra Neo / GO (I own …
-
Hi, there is a lot of documentation on how to connect an ADXL345 on a CB1 or CM4, and their configuration on Klipper. But I'm in trouble when I connect the BTT-ADXL345 to the BTT-PI by the supplied ca…
-
Hey there and thank you so much for dis conversation. It works pretty good und im almost done. I did the tmc uart upgrade with my og mainboard but I can’t find information were the uart pins are after…
-
I have Kusba v2.4. I followed the open issues here but I can't solve my issue. It seems the device port can't be connected to.
I already tried to flush it with the Rampon Anchor 0.4 to no avail.
In…
shkup updated
4 months ago