-
Hi there,
I tried out the Ideetron LoRa Nexus Board with the ttn-otaa script that is supplied by this library.
After editing the required configurations and uploading to the board I noticed that the…
-
Hello dears
* This is my configuration:
1- LMIC Version: `v4.1.1`
2- IDE: `Arduino`
3- Board: `UNO`
4- Region: `EU868`
5- Radio: `HopeRF`
6- Network Provider: `My Server`
* Some about Ne…
-
There is a new board version TTGo T-Beam V1.0 which is not supported by this repository because:
- GPS Pins changed
- A Programmable power supply was added (AXP192) which has to be told to turn on t…
EccoB updated
4 years ago
-
**Describe your question or issue**
I am using Lora Discovery board L072CZ. Using the example helium-otaa. I used with platformio.
I Gave correct EUIs and AppKey, when running the program it seem…
-
I'm trying to build and upload the Multigeige v1.16.0 firmware into a Heltec wifi_kit_32 device using the Platformio IDE.
Unfortunately, from the documentation i only found a way using the Arduion …
-
Hi there,
I am working on Lora Iot development kit v 2 from Dragino in 868 MHz. I am implementing Lmic master for sendong Temp & Hum. to TTN using otaa. So, my single channel gateway is LG01. So ,…
-
Hello,
I think there is an issue with the antenna switching... But I'm not sure. Were you able to get this working as-is?
I assume the LMIC has to be extended with PA switching.
MAG,
Milo
-
The behavior of the LMIC changed between 2.3.2 and 3.10.0, which requires that apps be more careful about sending messages. With the upgraded MAC code, the LMIC and the network can get involved in len…
-
Hi! Is it possible that there will be support for the SX126x(especially 1262) chip? There is example for ping-pong comm between these chips but it would be quite difficult to implement lorawan into it…
-
If I send data to the device from TTN and I ask for a confirmation that the data was received using the LiMC stack, how do I send the ACK back to TTN?? I've looked at the code, and it should do the AC…