-
Hello,
I found my old 3D printer motherboard today MKS GEN L V1.0 8bit board.
Looking over it, it has many 5V and GND's and lots of data pins, Marlin is an open source firmware and unsure if that …
-
It seems that the number of sockets is determined in ethernet.h based on RAMSTART and RAMEND. But these facts are both defined for the mega chip instead of the W5100.
They are both defined in arduino…
-
```
The boards menu is really overwhelming and we need to simplify it.
Possibilities:
- auto-detecting the microcontroller / bootloader baud rate
- limited selection of boards that's customizable i…
-
```
The boards menu is really overwhelming and we need to simplify it.
Possibilities:
- auto-detecting the microcontroller / bootloader baud rate
- limited selection of boards that's customizable i…
-
I see some references to this that are quite old. It seemed to say this was fixed. But I just upgraded top the latest of Arduino and the IDE and they have identical issues.
(.text+0x0): multipl…
-
I am running Johnny-Five on a Raspberry Pi connected to two Arduino Mega 3's using the Firmata.
LEDs, Buttons, Potentiometers and switches all work fine following the instructions here:
https://jo…
-
Hi Huub, really enjoying CNCL and now working on getting Spindle Sync working and have a couple of questions that the answers may help others:
Using an Arduino UnoMega 2560 with the lates edge releas…
-
***Is your feature request related to a problem? Please describe.**
There are several click board shields that do not have proper support, which makes starting new projects more difficult than it nee…
-
```
The boards menu is really overwhelming and we need to simplify it.
Possibilities:
- auto-detecting the microcontroller / bootloader baud rate
- limited selection of boards that's customizable i…
-
```
The boards menu is really overwhelming and we need to simplify it.
Possibilities:
- auto-detecting the microcontroller / bootloader baud rate
- limited selection of boards that's customizable i…