-
Any plans?
-
Hello, I have created a PCB after referencing your first schematic diagram. Of course, this version uses TXB0104 with external Flash, but there is a phenomenon: the first time it can be successfully b…
-
Hi there,I have noticed that some case test pass with mannual , can I have a list of mannual passed cases
because I found those case in the report PASS
GATT GATT/SR/GAW/BV-12-C PAS…
-
**Describe the bug**
Not high prio, posting just for the record:
Zephyr controller rejects the LE Create BIG if the fallowing config settings are used:
- 441_1
- 441_2
- 48_1
- 48_2
- 48_3
-…
-
Hi, we're trying to use a u-blox gnss module on an nrf9160 based board, using the nrf sdk and pulling in ubxlib as a zephyr module.
We recently updated the nrf sdk to v2.5.x, and since then our appli…
-
Hello, I have encountered two issues.
First question: How can I use JLink for debugging in VS code? What are the minimum pins that JLink needs to connect to?
The second question: Reading sensor info…
-
**Describe the bug**
nRF53 Symptoms: Network core behaves erratically.
Refer to: https://infocenter.nordicsemi.com/topic/errata_nRF5340_Rev1/ERR/nRF5340/Rev1/latest/anomaly_340_165.html
**To Re…
-
**Describe the bug**
In the documentation, there is a few places where the source rst tries to define a `zephyr-app-commands` with a multiword "goal", but the rendered version is split into one line …
-
**Describe the bug**
I'm not able to setup a second CIS using nrf5340 with Zephyr Host + Zephyr Controller configuration and zephyr/test/bluetooth/tester app. In PTS BAP/USR/SCC/BV-135-C test case th…
-
Probe-rs does not seem to work with `STM32WL55JC` MCUs. Segger tools and openocd work fine.
Using a `nucleo-WL55JC1` dev-kit on Arch Linux.
with on-board st-link
```
> RUST_LOG=debug probe…