-
Hello,
I would like to integrate the esxp1302 code with Tasmota to take the benefits of sending any data over MQTT with 8-channel LORA.
Tasmota has already this capability, named bridge, but for si…
-
Hi,
I've been trying to get OMG (latest dev 46160c6) running on a GL.iNet GL-S10 device. This uses a ESP32-WROOM under the hood, together with a IP101 ethernet phy.
Full specs: https://docs.gl-ine…
-
I was thinking to use this project for a quality temperature/humidity sensor with e-paper (Wavershare, 1,54" 200x200 pixel) with LiPo battery.
I would need some help to add support for a SHT31 temp/h…
-
Hi @1technophile,
Sorry to make an issue for this, didn't know how else to contact you.
I'm so glad I found NewRemoteSwitch. Finally I can use my trust smart home products (remote and switches) …
-
Hi I'm trying to decode a remote control but no matter how I press it I don't get any messages. Please help. I have tested the receiver from the transmitter(SendDemo) and it is working
The sample I…
-
**Describe the bug**
My weather station reports `rain_mm` = 4472.1001 in typical rtl_433, tested with two different receivers. When using OpenMQTTGateway, it instead reports `rain_mm` = 3786.378.
…
-
here is my esp32 log
-----------------------------------------
ets Jun 8 2016 00:22:57
rst:0x1 (POWERON_RESET),boot:0x13 (SPI_FAST_FLASH_BOOT)
configsip: 0, SPIWP:0xee
clk_drv:0x00,q_drv:0x00,…
-
Hello,
I followed all step of the tutorial and the gateway works.
But i only see Apple devices (iPhone, iPad, Apple Watch) but not other devices.
I have a bluetooth tracker (Tile mate 2022) and i d…
-
I'm trying to add support for my remote: a DiO.
A sample recorded with SimpleRCscanner:
```
120,116,192,740,352,1124,224,188,120,76,548,440,400,356,116,1148,260,408,568,752,464,1528,296,120,140,2…
guyou updated
3 years ago
-
Hi there,
I have used the library together with an ESP8266, and try to put some codes into a clone remote keyfob.
I would like to use a 32bit value, but cannot get it to receive the learned value. An…