-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
vke updated
10 months ago
-
This is feature request is for Matter (Project CHIP) compatible "Thread Border Router" OpenThread firmware for Elelabs adapters.
@NilsBohr Great to hear that you will release OpenThread firmware fo…
Hedda updated
2 years ago
-
Hello,
I installed the OTBR firmware on the espressif border router dev board.
When i enable NAT64 on the border router only the prefixmanager is visible when i check it with 'nat64 state'.
The …
-
@mercenaruss Can you please consider providing OpenThread Border Router (OTBR) "RCP mode" firmware images well as "NCP mode" firmware images (with support for the OpenThread `spinel+hdlc+uart` proto…
-
I tried to install openthread/OTBR as mentioned on the official website.
Here is the output
```
# podman run --sysctl "net.ipv6.conf.all.disable_ipv6=0 net.ipv4.conf.all.forwarding=1 net.ip…
-
**_Reported by Andrei Laperie:_**
OpenThread released by Nest is an open-source cross-platform implementation of the Thread networking protocol. It is hosted at github: https://github.com/openthread
…
-
https://github.com/openthread/silk/blob/3b29c48c1767132213be23a6ca7abe37df0b261d/silk/tests/openthread/ot_test_off_mesh_route_traffic.py#L227
-
@omerk Can you please consider providing OpenThread Border Router (OTBR) "RCP mode" firmware images well as "NCP mode" firmware images (with support for the OpenThread `spinel+hdlc+uart` protocol) an…
-
**_Reported by Andrei Laperie:_**
Relevant parts of the networking management interface specified in include/net/net_mgmt.h and include/net/net_event.h needs to be implemented for OpenThread to allo…
-
Executing docker command:
docker pull openthread/codelab_otsim:latest
failed with : unauthorized: authentication required