-
I'm trying to build with arduino-cli, which works fine after installing some libs which are not added as git submodules yet.
After building there is a /tmp/arduino-sketch-* folder, which contains the…
-
Hi.
I have an old PCB as described at https://otgw.tclcode.com/ (I bought from Node Shop few years ago).
Right now I'm using a remote connection with otmonitor an a ESP8266 with Ser2Net (ESP Eas…
-
Hi Robert,
In regards to your PM, I'm posting the same question I also posted on the domoticaforum.eu here.
For original post: [https://www.domoticaforum.eu/viewtopic.php?f=75&t=13381&sid=132eba…
-
### Feedback
Can the default TCP port be mentioned in the 'configuration / path' section:
According to this topic : https://www.domoticaforum.eu/viewtopic.php?t=13438&sid=f0c7225c9f97a60dd771088…
-
Hi, how can i get the choices: Heat, Cool and Fan (add Fann and Remove auto)
"accounts": [
{
"name": "MyFan",
"language": "12"…
-
Hello, not an issue, just a question.
I am using OTGW integration for long time. It's work great! Only every start-up of HA I got error:
Command PR with value D raised exception: Bad Value: The co…
-
### The problem
After the initial connect Opentherm Gateway disconnect and doesn‘t do anything any more. After Restarting the integration it works once an then stops again.
Ot-Monitor doesn‘t sh…
-
Hi everyone , I have installed 9 of these Eurotronic Spirit TRV on my radiators - controlled by home assistant. All looks good from the automation stand point, with the TRV's changing their target t…
-
Currently HomeAssistant doesn't see any of the OTGW sensors etc after a restart of HomeAssistant.
This is because HomeAssistant will check the MQTT broker when starting up, and any devices that are …
-
I just discovered that using D8 (GPIO 15) toconenct a DS18B20 with the recommended pull-up prevents boot. I haven't investigated much further, but it seems that GPIO 15 is involved in bootmode selecti…