-
Necessário criar esquema dos resistores da placa base, com as trilhas de cobre e seus resistores posicionados em cada encaixe.
-
## Expected Behavior
ppolyf_u_2k_6p0 has a sheet resistance of 2k/square.
## Actual Behavior
The resistance is much lower than this (68 ohm).
This is also true for the other ppolyf resisto…
-
Resistors values must change given as below
R5 -- 2K2
R6 -- 10K
R7 -- 4K7
-
I don't think i get the reason for the resistor in parallel with the LED. Is it the current limiting resistor?
-
Looking for ways of making comparators more convenient to use, and more compact.
Voltage Injector - Basically like the Redstone torch, but instead of providing the full power level of 15, have a wa…
-
Since the voltage is measured by resistor divider, it will be affected by the temperature drift of the resistor, and the heating effect of those 20Ω resistors is still very obvious. I decided to add a…
-
Hello! Suddely yesterday leds don't works anymore. Today, they start to working again, also rebooting they work perfectly. Just one thing: I do not read information about resistors or capacitors in th…
-
Hello.
In this pic, I expect the bottom meter to read 5A, and the one on the left to read 7A:
![01_resistor_setup](https://user-images.githubusercontent.com/18412921/43942282-575d2186-9c45-11e8-80b7…
-
Notice the pcb layout has the MPULL and SPULL resistors shown as 100K while the schematic and BOM show the value as 10K. Not a big issue but though I would mention it. Otherwise the board design is ve…
-
Unfortunately, I am unable to establish a connection through the Heidelbridge.
I followed your instructions carefully:
- Set S4/4 and S6/2 bit 1 as instructed
- Verified the pin connections
- C…