-
Is there any possibility of getting a lock accessory for this plugin?
jat80 updated
2 months ago
-
### The problem
I have updated my sonoff basic today.
After the update the sonoff was not available anymore in home assistant.
I bit the bullet and crammed it out the corner in order to reflash…
-
I'm using homebridge-mqttthing with Sonoff L1 Strip light. Homebridge and the Tasmota web interface are exchanging the correct status when toggling the light.
When changing the light level from Tasmo…
-
Hello @AlexxIT
First off, thanks for the work on this integration!
I see quite a few past issues about power reports and so on, and I hope I've covered my bases here!
I'm using auto mode, …
-
Hi there. Been having a problem getting the app to work with my sonoff RF bridge flashed with tasmota.
My setup Homebridge on pi, Sonoff RF bridge running Tasmota 8.1.0, Eclipse Mosquitto on the s…
-
### PROBLEM DESCRIPTION
_A clear and concise description of what the problem is._
I have a Sonoff POW Dual R3 running Tasmota 13.4.0(tasmota32)]
I set up "MaxPower 300" command to switch off …
-
As eWeLink will stop provide the support and maintance of current APPID & APP secret on Aug 31th 2020.
That means that this project may work improperly.
eWeLink will offer a special APPID and A…
-
Hi,
in my sonoff basic R2 I don't have GPIO14. Close to the 4 holes (3v3, gnd, rx and tx) I have a pad marked IO2, without the hole. And if I drill the hole, I risk to break the upper side tracks...
-
### What happened?
I was using my Sonoff SNZB-04 door sensor with ZHA for months and it was working fine. I switched the zigbee2mqtt and everything seemed fine at the beginning but then I started to …
-
Hi Alex,
could you add the support for the new SONOFF Zigbee Human Presence Sensor | SNZB-06P:
https://itead.cc/product/sonoff-zigbee-human-presence-sensor/?utm_source=itead&utm_medium=homebanner…