-
Great project. This is what I was looking for. I ordered what you have here in the description and the WiFi LoRa 32 (V3) arrived. I can't install it because it keeps giving me errors. I'm new to this …
-
I'm trying to make this gateway work with an EBYTE E22-900M30S module directly wired to the pins as described on the README without success. I have tested this with the 32 and 64 bit images.
RPI P…
-
I would like to use this library in your project but it's C++ : https://github.com/jgromes/RadioLib
@nopnop2002 Sorry for annoying you with that.
Do you known if there's a simple way to do that ?
-
[Pixhawk standardní SPI konektor](https://raw.githubusercontent.com/pixhawk/Pixhawk-Standards/master/DS-009%20Pixhawk%20Connector%20Standard.pdf) má kromě SPI signálů pouze jeden další signál, jehož p…
-
I was excited to see your project. I have a T-Watch S3 and it is very frustrating to try to develop software for. Is there any way that I can help you? I am an experienced Python programmer and hav…
-
### Category
Hardware Compatibility
### Hardware
Rak11200
### Firmware Version
2.2.23.567e68, 2.2.16.1c6acfd
### Description
I'm experiencing a boot loop with my WisBlock setup.
Using RAK190…
-
Hi, I am using LoRa SX1262 Raspberry Hat with Raspberry Pi. This is the issue I am getting when using the Network Examples reciever.py code
Begin LoRa radio
Traceback (most recent call last):
F…
-
I was installing the network node from network folder , but it throws this error when pressed run. Can anyone resolve it?
-
Is possible instal RNode softweare with nomadnetwork?
Please make a softweare for this network
-
When on solar and the battery runs out, the board will probably shut down. When the sun returns and there is some solar power available again, there must be some way to recover. Without any special ha…