-
Hello everybody.
I have a SKR PRO board that I wanted to use for a small CNC router project. I've been trying to get the trinamic TMC2209 drivers working for the past few days to no avail. The firs…
-
Hi! I have a TMC2209 silentstepstick driver connected to a custom PCB that I made.
I am using this library to communicate with my driver, this is the code (it's a slightly modified example present in…
-
Hello - I'm testing the TMC2209 BIGTREETECH v 1.3 drivers without UART config and no matter which microstepping option I set via MS1/MS2 pins or what potentiometer value I set (tested max clockwise / …
-
![image](https://user-images.githubusercontent.com/103623250/167797511-869f36a5-f616-4242-8a28-aff704433529.png)
I get this error while compiling if i set TMC2209s up in UART mode:
![image](http…
-
Has anyone had any luck controlling a TMC429 over SPI and two (2) TMC2209 stepper drivers over software serial UART as described in the datasheet?
![TMC429_controller_TMC2209_driver](https://user-i…
-
Would it be possible to use GPIO16 and GPIO17 for UART interface to connect Trinamic drivers tmc2209/2226? It would be preferable if a board uses SPI interface for SD card only or together with SPI To…
-
Marlin-Ai3M-2.0.x paired with TMC2209s (0.86v current on each, upgraded cooling, stealthchop enabled) causes random Y Layer Shifts (random in both time and direction) using Marlin2-Ai3M-v2.0.0_TMC220…
-
Hi,
My setup with an Adafruit M4-expressboard with a bigtree TMC2209 works when I use serial1.
However I need the serial1 fo a GPS shield, so I created Serial2 by using sercom code.
This created s…
-
What component do I need and where do I add it? to block the interference?
-
Hello, I have a BTT SKR2 board and Fysetc TMC2209 v3.0 drivers. The board has Marlin firmware loaded (I've tested on several versions, and same error) to work with the rev b model board and F429 ch…