-
I'm writing a config based off of yours. looks like you designate A4988 drivers in config.h. not sure if this has changed, but the kp3s now ships with removable TMC2225. was this the case when you dra…
-
Hi there
I try to find out how the ENDSTOP PHASE section in the config should looks like.
I started to add `[endstop_phase]` into my config and go multiple times for G28 and `ENDSTOP_PHASE_CALIB…
-
I have been through the list of Pins at the top of the Duet-Duex config file and am unable to see any reference to temps for the MCU and Steppers, as I would like to view them on MainSail.
RRF uses '…
-
@KevinOConnor Hi I am just getting started with Klipper and so far it is great but the only problem is the lack of the CoreYX kinematics.
I did look at `./klipper/klippy/kinematics/corexy.py` but i h…
-
Hello i want to run two motors on one USB port.
However if i do so only one motor turns and the debug is telling me a different module-ID
i set one motor to module id 3 and the other to 4. (ic h…
-
I have the 2208 drivers which get configured via UART. I have a power supply which gets turned on when starting a print.
It would be great if I could add a command in my startup code to initialize t…
-
### Did you test the latest `bugfix-2.0.x` code?
No, but I will test it now!
### Bug Description
I'm new to Marlin, and relatively new to 3d printing. This is my first printer, Ender-3 with 4.2.2 M…
-
Is it possible to get the ability to use software spi rather then hardware on a ramps/mega setup with TMC drivers. This would help many Marlin converts not have to rewire their setup.
-
### Updates
* **25-07-2021**: Updated build environment info.
* **25-07-2021**: Added info about auxiliary serial port
* **25-07-2021**: Updated info about display ribbon mod
### Descripti…
-
https://github.com/MarlinFirmware/Marlin/pull/16790
Marlin just got a pull for coolstep, dont look too bad to implement in klipper. it wuld be abselutly perfect for 3d printers, wich are what kli…