-
with the new version of jyers the nozzle temps extremely fluctuating between 190 -210 by an setted tem of 200.
i have done a pid tunnig , its done ok but after saving the fluctuating nozzle temp also…
-
From few days i have been trying to start dual endstop for Z line.
SKR 1.4 TURBO + TMC 2208 UART
All motors from all axis works.
Issue: when i try home positioning Z axis Z_MIN stops both Z driv…
-
Hi, first of all thank you very much for your work on this library.
I did not understand how the pin "m0_enable" is connected in your documentation (found here: ShushEngine/shush/boards/shush_mk1.…
-
Using Marlin 2.0.7 the endstops do not stop the motor when homing -- using the TFT 320x240 setting with the HAL STM32 builder.
Pinging M119 and manually triggering endstops individually do show the…
-
Hello,
I am trying to get up and running with TMC5160-BOB using the SPI example. The break out board https://www.trinamic.com/support/eval-kits/details/tmc5160-bob/ comes pre-configured for SPI com…
-
Hello, will there be support for the TRAMS in Marlin?
-
Hi, my setup is almst done (missing frame pieces), but i can adapt the ectronics to the machine
what is the minimun requirements (inputs/outputs) for this project?, (a Fysetc AIOII https://github.c…
-
### Description
I am using the tmc2130 stepper motor driver and I often rely on M503 to make backups of my machine settings, but I found that the M913 setting for TMC hybrid threshold speed is not sh…
-
I have just installed klipper branch 20180220a on my Anycubic kossel delta with trigorilla board + RPi3b and a few lines after the print has started one of the stepper motors turns off (i can move it …
-
There is a board on ESP32. Compiled the firmware based on Marlin 2.0.9 and Esp3dlib. But there is no connection between the WEB interface and the firmware. A similar GR BL firmware works on this boar…