-
This is my RS485 config on boneblack.
`&am33xx_pinmux {
uart1_pins: uart1_pins {
pinctrl-single,pins = <
0x178 (PIN_OUTPUT…
-
https://github.com/cleolibrary/CLEO4/blob/07df6640da04799118f6273d55ffbb0f4239ccf9/CLEO4/CScriptEngine.cpp#L653
This may cause a crash if you load/unload TXD many times.
https://sannybuilder.com/for…
-
This is from [*The Job*](https://ifdb.org/viewgame?id=g5rflxpmycdl67ps).
I've trying to track down a bug in TXD and noticed this:
TXD:
```
Routine 25d4, 4 locals
25d5: 36 04 1e 00 …
-
Hello,
I noticed that the valid clock sources for UART0 are:
* HIRC
* 32.768khz LXT
* PLL OUT
* 4~24MHz HXT
depending on the value placed into UART0SEL.
Since `LIRC/LIRC32` is not an opti…
-
#include
#include
#include
#include "BTHC05.h"
#include
#define BTHC05_PIN_RXD 10
#define BTHC05_PIN_TXD 3
#define PIN_RST 2
#define PIN_SDA 4
String read_rfid;
void Se…
-
При подключении нескольких устройств URM37 на одном из устройств(последнее проинициализированное устройство будет работать) при чтении появляется ошибка timeout.
ide: arduino 1.0, на старых версиях 2…
-
Hello,
I am trying to understand how the Firmware can be debugged.
- Which Pins are used to communicate with the MCU ? Where is that configured in the FW?
- This version of the BHT002 Hardware …
-
I had a problem to setup the serial communication with _Serial.begin()_, with the Attiny3224 MCU. After several investigations I found that the problem was the baud calculation. Finally I managed to m…
-
Hi, can I send, only with this display, some digital commands trough rxd txd ?
For example if I make a button ON, when i press him, this send via rs232
$18 $00 and for OFF button $18 $01
thank…
-
Does the board have a way to control the backlight brightness via GPIO?
I see in the schematic:
![image](https://user-images.githubusercontent.com/15969459/124366349-7649b080-dc4f-11eb-8f31-319ced…