-
### What happened?
Testing a problematic AU wall socket in z2m-edge. Originally was only exposing one or two sockets (but power reporting was exposed) https://github.com/Koenkk/zigbee2mqtt/issues/235…
-
Hello, I am a postgraduate student, recently learning distribution network partition and voltage control. I have seen your question in issue of DeanZeng( https://github.com/DeanZeng/Power-gird-partiti…
-
I updated all the files 9/26/24.
I'm having an issue getting three Voltage Controlled Resistor models in the link below to work in Qucs-S.
http://www.ecircuitcenter.com/Circuits/vc_resistor1/vc_r…
-
Im trying to run the examples single_inverter_current_control_safe_opt.py and single_inverter_voltage_current_control_safe_opt.py.
Both have an issue with the reward function.
Specifically, the l…
-
**Describe the bug**
Alternator PID Output stays at a high value after we're past the target voltage for a while, eventually starts lowering
**Hardware**
- Board: [4chan revI]
- Engine info [M…
-
I seem to get this error all the time where I have plenty of excess PV power available, and the appliance just will not switch on. Sometimes it works, sometimes it does not, and I don't know what's ca…
-
Define the requirements and follow-up design goals for the power management on v4.x boards: powering the device, charging the battery, power-on/power-off, protection.
DEFINITIONS (loosely based on AX…
-
The +/- 9V DC to DC converters are becoming very difficult to procure; suggest changing to +/- 12V 1W converters instead, ensuring 4.7uF capacitors are appropriately rated. The Op-Amps can operate wit…
-
Hello,
I have the Thingsboard Gateway v3.5.1 last snapshot build installed in a docker environment on a Ubuntu 24.04.1 LTS server. I have some devices connected to Thingsboard Gateway throught centra…
-
Hi:
I'm not sure how to explain this but it seems that the setting of the switch that connects the voltage input opamp to either the original single I/O pin on the connector or new input only pin o…