-
Update: master 0.9 is out.
Plan is to have a final master 1.0 by end of 2021, open issues that possibly (likely?) will be added until then:
Decoders
- [ ] Check DFM data quality (clear all data…
-
Hey guys, i've spent way, way too much time trying to get the zigbee board to work. I've followed the youtube video Academia has put up. However i get issues with esp_littlefs mount failed once i swi…
-
Hi,
I am trying out this simple helloworld code:
https://techtutorialsx.com/2017/12/02/esp32-arduino-interacting-with-a-ssd1306-oled-display/
Would it be possible to add such example to your …
-
Yes, this is a hardware issue, not software, not sure where to post about hardware issues other than here. My Stefly OV is producing a lot of RF noise that messes with my radio (Dittel FS2T). Most o…
-
Any idea on how to adapt this to Z10? Doesn't work with either 0x09 or 0x11.
Would really like this for my Z10.
-
Bug:
On first boot after unit gets valid GPS signal, first TX takes ~35 seconds to complete,
Not seen the unit do any further smart beaconing, doing a manual TX (central button short press) it does …
-
I have had 3 boards die ( technically 4 but that was my bad, connected battery backward and poof it dead )
I am using an external battery back 3s3p 18650s that output ~11.1v, this is inputted into a…
-
Hi
The pinout diagram should be updated to reflect that pins 32 and 33 are only capable of output (GPO), and pins 34, 35, 36 and 39 are only capable of input (GPI).
See this official Espressif d…
-
Hi there!
Not really an issue......but...
Is ESP32 platform supported?
And if "Yes" are the benefits significant? Where's to find the build Tut's?(i guess it should be the same)
I mean besid…
-
I have roughly the following setup
I have an ESP32 TTGO with ST7789_DRIVER
`CGRAM_OFFSET` is defined
my code is:
```
TFT_eSPI tft = TFT_eSPI();
TFT_eFEX tft_x = TFT_eFEX(&tft);
tft.begin…