-
Hi
Am using Tevo tornado firmware 1.1. I am able to connect and monitor the prints. However, for a print more than couple layers, the print gets paused automatically after 2-3 layers.
The printe…
-
Hi,
Device: Raspberry PI4 2GB
motionEye Version | 0.42.1
Motion Version | 4.2.2+gitUNKNOWN
OS Version | motionEyeOS 20200606
Not sure why, but for some reason my motion eye keeps crashing, it…
-
When two lines have the same "title" AND "year" AND "authors" keep only one (the first? the most complete?)
Below the three key in ISI and SCOPUS:
- title --> ISI = TI / Scopus = Title
- year -->…
tommv updated
3 years ago
-
Hi,
Thanks for creating this, I've wanted to connect to my unit for a long time!
I installed the plugin and used the configuration below. I have a Daikin unit with 3 temp sensors in different room…
-
Hi Claude!
You probably have seen following mail:
_Dear
{{ insert first_name 'default=default' }} {{ insert last_name 'default=default' }},
an
evaluation has shown that you have used the…
-
### Expected behaviour
Docker for Mac should launch as it has previously and not start consuming high amounts of CPU resources, even when "idle".
### Actual behaviour
Starting Docker for Mac spawns …
-
Hello Proddy,
Is it possible to extend the supported Solar Modules to include the Bosch/Bruderus SM200.
The second device is a Sense II module that is working as a passive display.
Here is the outp…
-
### Description
My printer homing fails after printing it is a delta printer (Anycubic Kossel linear plus) it was printing fine and out of nowhere it started with this problem.
The printer homes fi…
-
During printer maintenance it is often necessary to cancel ongoing update of the chart and start over. Right now, the only 2 ways to "get out" are either to wait for timeout, or to restart Octoprint. …
-
I updated the new version of octoprint today.
every time i try to start a print the connect gets lost. if i go back to the last version 1.2.10 everything works fine.
it is a delta printer and the pr…