-
Hello,
im experiencing a extrude below min temp error without a reason.
The extrude_below_mintemp is set to 170.
My printer is randomly stopping printing with the error, but keeps the heater on a…
-
After switching to python3 bed mesh calibration works incorrectly.
With python2 it probes points:
```
--x--
-xxx-
xxxxx
-xxx-
--x--
```
after switching to python3:
```
-xx-
xxxx
xxxx
…
-
Klipper v 0.10.0-223
I have the problem that my probe of the Anycubic Vypers (straight gauge) after he has been triggered goes even deeper and this gives me permanently wrong measuring points - wit…
-
if print a cylinde
mega2560 +ramps 1.6
machine with marlin work fun ，
same machine with klipper print will incline like a Leaning Tower of Pisa
bytes_read=106438 bytes_retransmit=496 bytes_inv…
-
I just spent a whole day getting Klipper going because everyone raves about it. Now I find that I cannot move anything using standard GCode if the machine doesn't THINK it's homed.
I read the FAQ a…
-
by now I have tried everything, I am bent on printing a circle and from any point I start (rear, right, left, front, 45º fill, 0º fill) wherever I start, in that point the nozzle is generally high and…
-
Hi @KevinOConnor ,
according to https://github.com/Klipper3d/klipper/issues/2356 the inconsistent parameter calls should be fixed.
I´m trying to get a T0 and T1 macro working for a manual filame…
-
I've had this happen a a couple of times now where for some reason Klipper can't find the DS18B20 sensor and resets the FW.
Problem is when this happens in a print it is ruined.
In the attached fi…
-
Hi!
I'm bulinding a Voron Legacy and wanted a Klipper firmware to it. I have a RPI-zero, an SKR mini 2, and tft35 display. I watched NERO 3D video's video about it and doing the stuff step by step. B…
-
I have been struggling with the Resonance Testing section of Klipper.
It seems that these instructions and much of the code were written for python2, but on rpi4, this is a non starter.
In particu…