-
Hi, Can you provide an example on how i can catch data from a connected mouse?
the mouse gets detected, but nothing more then that. if I plug in a keyboard i at least get raw data
![photo580524479…
-
Is there a way that we can get this to....
- Auto update?
- Print to specific Avery Labels?
- Maybe add a front end to this in the future to pick and choose which sets we would like to print?
-
-
Every now and then when reloading a save, my game simply freezes (its still running) and wont load.
I've asked the BetterLoading Dev to take a look at my logs and he said that maybe the culprit is: …
-
So, while discussing signage with @iteles, she suggested that we look for a food-grade, non-toxic varnish, especially if we plan to place some signs in the kitchen.
When finishing laser-cut wood si…
-
Since the new Pro models 24 and 36 (and fusion maker and fusion edge) came up, 32 was cut off from official homepage and other sources except legacy archive (https://www.epiloglaser.de/Lasermaschinen…
-
I just recently got the SKR V1.3 for the wiring simplicity and 32 bit stuff. Sadly, this has also created a few issues. The SPI jumpers are in the correct places and the +5V is in INT like it is suppo…
-
Validate fit of
- [x] GPS Front
- [x] GPS Back
- [x] Clock Front
- [x] Clock Back
- [x] Blink Front
- [x] Blink Back
-
I'm thinking of setting this up on a common 3D printer platform (Arduino Mega 2560 + RAMPS 1.4 + LCD w/ SD card reader), and I'd like to make it run standalone (like Marlin does).
So, I figure I'm …
-
Since last lens adjustment by the laser support guys at 01.06.2022, lens adjusting has gone again. This results in bad cuts at the bottom-right sector of the vector grid:
 :
- les sondes de courant sont affectées par le bruit des relais (c…