-
Hi,
I've been using Slic3r for a year or so. Just downloaded V1.2.9 and can't get it to work. If I try launching from a terminal, I get
Can't load '/home/glenn/Slic3r/lib/vrt/9e109cfe461eb9a764d581…
-
I have a 0.6mm nozzle (as measured by the extruded strand after drilling by hand). It seems to work OK with 0.5mm settings while diagnosing this problem, but it's still definitely bugged.
When slicin…
-
This is the short gcode header version I get from ver 1.1.1:
; generated by Slic3r 1.1.1 on 2014-04-24 at 09:24:03
; perimeters extrusion width = 0.35mm
; infill extrusion width = 0.52mm
; solid infil…
-
It gets blocke when exporting gcode for any STL
; generated by Slic3r 0.9.9 on 2013-04-07 at 10:32:41
; layer_height = 0.15
; perimeters = 3
; top_solid_layers = 0
; bottom_solid_layers = 6
; fill_d…
-
Hey guys,
I got over a problem lately with Slic3r 1.1.7.
I found out that if you use multiple geometries sometimes retraction is not done inside the geometry but the printhead moves outwards first (…
-
**Slic3r Version**
1.2.10-dev (commit ID 2d1bf3ce439984e0f38c62560898bae30305f0a5), built from sources. Also present in 1.2.9 and 1.3.0-dev.
**OS**
Linux version 2.6.32-604.30.3.lve1.3.63.el6.x86_…
-
### Slic3r version:
0.9.1
### Operating system type + version:
Windows 7x64
### STL used:
[20mm Hollow Box](http://www.thingiverse.com/download:17279)
### Issue Explanation
I expect to see straigh…
-
### Version
1.2.9-637-g62675a2b
### Operating system type + version
Arch Linux 4.4.52-1-lts
### Behavior
In a model with an horizontal gap in the border which width is close to the perimeter …
-
I tried slicing an STL file (below) in the latest Slic3r and it says 'no layers were detected'. But it worked fine in an older version of Slic3r from 3-4 months ago with the same config file. What is …
-
#### Version of Octolapse
Octolapse Version: v0.3.1
#### Version of OctoPrint
OctoPrint Version: OctoPrint 1.3.7rc3 running on OctoPi 0.14.0
#### When you ran into the problem, did yo…