-
```
For safety on ground it is paramount to know whether the motor controls are
armed or not armed. As per default it is only signalled on the APM board on a
little, in many installations partly hid…
-
```
For safety on ground it is paramount to know whether the motor controls are
armed or not armed. As per default it is only signalled on the APM board on a
little, in many installations partly hid…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
```
What steps will reproduce the problem?
1. Set the mode switch to FBW_A at any point.
What is the expected output? What do you see instead?
Expected output: Control surfaces should respond to iner…
-
I guess CTL is the only livery with textured spinner (since the paint is so worn) - I noticed it doesnt spin with the propeller.
To make it work, one also needs the blurred "highspeed" textured spinn…
-
```
I loaded my 1280 mega board with the latest v2.5.3 firmware with the APM planner
The problem which I am facing is that when I arm motors and increase throttle
till just the position where the mo…
-
```
For safety on ground it is paramount to know whether the motor controls are
armed or not armed. As per default it is only signalled on the APM board on a
little, in many installations partly hid…
-
I am building my first quad and have run into some problem of which I can not find answers on.
The hardware is a stock TX turnigy 9X with stock receiver (9x 8C V2) with RXC 12A ESC, DYS BE1806, and F…
-
Here's an excerpt on an off-line discussion about where Grbl is going and what's next:
**chamnit** : This is something I've been thinking about often recently. Is Grbl done? Or have we pushed it abou…
-
```
It's simple numbers. The loop contains a hub operation which makes the loop
time 16n. 40 isn't. So they interfere with each other. I'd suggest to add a
note that the sample time must be a multip…