-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
I'm getting it to upload to my 1MB ESP-01, but my ESP-01 won't create a network... Any solutions? The SPI speed is 40MHz and the SPI mode is QIO. Should it say "is stub and send flash finish" when it …
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have up…
-
It seems that the current 3.5 upper computer does not support spi nand writing
-
### Answers checklist.
- [X] I have read the documentation [ESP-IDF Programming Guide](https://docs.espressif.com/projects/esp-idf/en/latest/) and the issue is not addressed there.
- [X] I have updat…
-
Hi Professor Takasu, I uploaded the F/W on PocketSDR 2CH using the technique you mentioned in your article: https://gpspp.sakura.ne.jp/diary202109.htm#0923 The process completed successfully, and I go…
-
I need 3 sensors, but there are unfortunately only 2 I2C addresses. So i have to use SPI instead of I2C. Is there a way to use the same library in SPI?
-
Hello, I am developing the firmware for TI MSP430F5438A to control MPU-9250 via SPI.
However, I found that the result which I received is so strange.
This is the result of acceleration when I put the …
-
Hi
I have to use ethernet with Arduino for my project which requires the SPI pins of Arduino.
Is it possible to use the remaining pins to output to the display?
Thanks!
-
Hi there,
I tried to use (kmod) spi-gpio-custom but I can't opkg it, I just saw it's not on the repo. As i2c-gpio-custom is in, would it be possible to add the same for SPI ?
thank you for your help…