-
Following the docker instructions and building the containers results in the following error:
Step 16/18 : RUN make TARGET=minimal-net
---> Running in 4562cb6df09f
mkdir obj_minimal-net
CC …
-
Please excuse me if this has already been answered. I've seen many similar posts but could not figure out the complete solution to my problem.
My setup is a Beaglebone Black edge router connected via…
-
All of a sudden I am gerting authentication failed error for my email address. I reinstalled but no luck. I didnt change anything which might have made this error happen
-
Devtools has network initiator traces. We also have ResourceFetcher::requestresource traces. Lets figure out what they are and have one principled solution.
@caseq @chiniforooshan
-
After entering deep sleep it looks like the MCU is being woken up roughly every 50ms for some reason. Tested rpl-udp/very-sleepy-demo and on 2650STK as well as a custom 2650 board with no sensors on a…
-
I try to send rather large packages (payload between 500-900 bytes) to a jn5168 based node. It works _mostly_, but I also see some `sicslowpan input: Dropping 6lowpan packet that is not a fragment` er…
-
Hi,
I have a CC2520 module and wonder if it can work with the Arduino 101 board. I'm trying to compile the Zephyr app with CC2520 module, but it failed. I'm using Zephyr 1.5.0 release. Below is the…
-
As discussed here:
http://sourceforge.net/mailarchive/message.php?msg_id=31642373
_Encryption and security was always missing in Contiki. At Thingsquare, we
have successfully been using AES encryptio…
-
Hi,
I have some CC2650/CC1310 code that I want to simulate in a large mesh network, so I have adapted the code for COOJA since there is no native CC2650/CC1310 mote type.
The code compiles but when …
-
There seems to be an issue with the set_tx_power function. By default, the transmission power in IEEE mode is output_power[0], which corresponds to +5 dBm. At a distance of 10cm, a CC2531 USB dongle r…