-
I'm using 28BYJ-48 stepper motor with ULN2003A breakout board and when I connect to the focuser, It always start in moving state to true. I have to go in the device hub, make a small move, then the mo…
-
I'm creating this issue to keep track of the progress on the various circuit board designs needed for SimplePnP.
Remaining work:
- Main controller board (very similar to the head mounted control…
-
I found and ordered drivers - lv8728, which work with 3.3 volts logic and can be used with more powerful motors, unlike lv8729. Do you need any changes in the firmware? What to write in the section st…
-
I'm trying to get dual y-axis working. I'm using the latest Protoneer RPi CNC hat v2.60 which the developer says has the same pinout as thier arduino cnc shield v3.51.
The board set to map the 4th …
-
I have an skr 1.3 with TMC2208 V3.0. I only insert the jumpers on the Red UART pins.
No matter what I do I only get errors on standard commands like M122:
Send: M122
Recv: echo:Unknown command: …
-
Congrats @JoeTodes on this great achievement on such a cheap printer.
I've recently installed Klipper on my Biqu B1, the learning curve is a bit slow, but i'm making progress.
I checked out your p…
-
My Anycubic Chiron is 100% stock.
and not customized in any way.
I download your repo today as ZIP
And have the most recent Arduino IDE (downloadet today to)
I did follow these instructions: …
-
While testing some stepper I noticed that they became rather hot even if the TMC2208 was configured with a conservative rms current using `rms_current(uint16_t mA, float mult)`
Checking current con…
-
Add Linear Advance on LCD setting on latest firmware
Please maybe you can ADD linear Advance on latest firmware so that it is easy to adjust on LCD Display..
Thank you
-
Hi Iv been using GRBL with protoneer 3.51 shield and drv8225 stepper drivers on a chinese 3040 machine and its great however I want to be able to command the spindle via GCODE to run closed loop thus …