-
Hi,
I tested the analyzer sctech at my System.
My setuP is a Watturino with a ATmega328P-AUR and a lin Chip TJA1021
A difference to your scematic is a 30K resistor for the slave termination (LIN St…
-
Hi,
I am following the procedure as per your suggestion...
But I am not able to build the project in Eclipse.
**It says the below error:**
![image](https://user-images.githubusercontent.com/95…
-
Hi everybody,
i am currently trying to implement an I2C connection between an ESP32-WROVER and a Raspberry Pi Pico (RP2040). The ESP is configured as master and shall request data from the Pico whi…
-
```
What steps will reproduce the problem?
1. Run the attached sketch.
What is the expected output? What do you see instead?
The LED should not turn on, but it does.
What version of the product are …
-
```
What steps will reproduce the problem?
1. Run the attached sketch.
What is the expected output? What do you see instead?
The LED should not turn on, but it does.
What version of the product are …
-
```
What steps will reproduce the problem?
1. Run the attached sketch.
What is the expected output? What do you see instead?
The LED should not turn on, but it does.
What version of the product are …
-
uno.bootloader.file=arduino:optiboot/optiboot_atmega328.hex
does not work
```
uno.name=Arduino Uno HID-Bridge
#uno.vid.0=0x2341
#uno.pid.0=0x0043
#uno.vid.1=0x2341
#uno.pid.1=0x0001
uno.upload.too…
-
```
What change would like to see?
The ability for the boards.txt file to specify two separate processors, one for
compilation and one for uploading. In particular, the ATmega328 isn't supported
by…
-
```
What change would like to see?
The ability for the boards.txt file to specify two separate processors, one for
compilation and one for uploading. In particular, the ATmega328 isn't supported
by…
-
Basically the same as issue 422 and 411.
Interfaces using CH340 USB bridge often fail to save configuration, always fail to flash. I've tried a random selection of approx 80 or so atmega328p w/ ch3…