-
Hi guys !!
Is there any compiled file for esp32 or esp8266 ... I have difficulty compiling.
thankful
Leandro Costa
Before submitting a problem please check the troubleshooting section
https:/…
-
Hi,
The IR_LG command is not working, it completely blocks my NodeMCU v1.0.
Serial output from LG TV Power button
```
Hey I got a callback
Receiving data by MQTT
home/commands/IR_LG
Callba…
-
https://community.home-assistant.io/t/433mhz-infrared-ir-to-and-from-mqtt-on-esp8266/6779/187?u=1technophile
wifi state
mqtt connection
sending or receiving
-
Actually i am using both function in same hardware(12E).
So, how to write any program?
How to enable and disable receiver function ?
If possible than put any example for combine function.
-
Hallo, frist of all, thank you for your good work!
I have installed OpenMQTTGateway on an ESP32, to connect a Remotesensor (a 433MHZ Sensor with temperature and humidity) with Openhab.
![remot…
joe63 updated
6 years ago
-
Hello,
(sorry for bad english, I'm french)
If I use only ZgatewayRF, no problem.
But, if I use ZgatewayRF AND ZgatewayIR, I have a problem with IP address (in serial monitor):
``
OpenMQT…
-
2 feature requests for the RF Bridge
When the bridge recieves any rf it sends something like the following to the topic
tele/sonoffrfbridge/RESULT {"RfReceived":{"Sync":11560, "Low":320, "High":…
-
Is it possible to repeat X times an IR message other than Sony protocol?
It would be useful for example sending continuous "volume_up" to an amplifier.
Thanks.
-
Hi All,
Does anybody know's why the BLE on the ESP32 is not working anymore after a few hours. I need to turn off the power and power it again. Below the messages when it is not working anymore:
…
-