-
## Expected Behavior
pressing Control + Alt + S
and choosing Build, Execution , Development -> openOCE Support
A dialog looking like shown in the blog. ie. something like this:
 is quite popular for embedded developmend, because is solves a lot of everyday tasks (dependencies install, firmware upload, build for multiple platforms)
It w…
-
### Description
The target is STM32L451CEU6 (custom target), mbed version is 2 (RTOS disabled), imported from CLI (last version), custom target specific files have been gathered from a STM32CubeM…
-
-
### Description
- Target : STM32F0xx, STM32F1xx
Using STM32CubeMX, it's possible to use UART in an inverted mode, by setting the members `TxPinLevelInvert` and `RxPinLevelInvert` of `UART_AdvF…
-
## Expected Behavior
It would be very helpful if you were able to determine the board configuration file based on the STM32CubeMX project that was imported. If this were done, the projects debug conf…
csann updated
6 years ago
-
After instaling prereqs, I find the "First Steps" somewhat too sparse to follow. No clear
"Create CubeMX project and select 'Makefile' as output file" method.
I opted to open the example. When …
-
## Expected Behavior
Building from an out-of-source `build` folder should perform the same build as in-source CLion builds.
## Actual Behavior
The builds are different (e.g. the out-of-source b…
-
### Configuration
**Operating system**: Ubuntu 14.04
**PlatformIO Version** (`platformio --version`): 3.6.0a10
### Description of problem
Some build flags are duplicated if defined via `bu…
-
### Configuration
**Operating system**: Ubuntu 14.04
**PlatformIO Version** (`platformio --version`): 3.6.0a10
### Description of problem
Some build flags are duplicated if defined via `bu…