-
Hi,
I tested the analyzer sctech at my System.
My setuP is a Watturino with a ATmega328P-AUR and a lin Chip TJA1021
A difference to your scematic is a 30K resistor for the slave termination (LIN St…
-
have tried with an atmega1284p, have tried with an uno and a nano, both mega328, and a mega2560, none can flash a sketch from arduino,
```Resetting the board
Failed to reset the board, upload fai…
-
```
What change would like to see?
The ability for the boards.txt file to specify two separate processors, one for
compilation and one for uploading. In particular, the ATmega328 isn't supported
by…
-
```
What change would like to see?
The ability for the boards.txt file to specify two separate processors, one for
compilation and one for uploading. In particular, the ATmega328 isn't supported
by…
-
Basically the same as issue 422 and 411.
Interfaces using CH340 USB bridge often fail to save configuration, always fail to flash. I've tried a random selection of approx 80 or so atmega328p w/ ch3…
-
```
What change would like to see?
The ability for the boards.txt file to specify two separate processors, one for
compilation and one for uploading. In particular, the ATmega328 isn't supported
by…
-
```
What change would like to see?
The ability for the boards.txt file to specify two separate processors, one for
compilation and one for uploading. In particular, the ATmega328 isn't supported
by…
-
```
What change would like to see?
The ability for the boards.txt file to specify two separate processors, one for
compilation and one for uploading. In particular, the ATmega328 isn't supported
by…
-
Soooo, been experiencing this now
Here's the error message
`
Arduino: 1.8.13 (Windows 10), Board: "Arduino Uno"
D:\Arduino\arduino-builder -dump-prefs -logger=machine -hardware D:\Arduino\h…
-
4Way Command DeviceReset
send's 0x00 0x00 0x00 0x00 to the ESC
normally there should be no response from ESC
But....
if you use BlHeli_32 Suite with AM32 Firmware you get C1 (unknown command) …