-
#### Description
When cable is SFP/SFP+/SFP28, most key names are not consistent between "show interfaces transceiver eeprom -d" and "sudo sfputil show eeprom -d". For branch 202205, the outputs …
-
**Question**
Hi, I want to put a mpu-6050 on the same bus of eeprom to using hardware i2c-0. I already soldered the giroscope on Tests Points on the lego ev3 board(SCL and SDA), but the eeprom uses…
-
### Describe the problem
We use GNU gettext for translating strings for embedded systems, with our programmers providing human-readable cues for things like maximum character length via the extract…
-
ST M95P32 : SPI EEPROM, 32 Mbit
-
When reading EEPROM via avrdude using wiring (via bootloader) - results are corrupted. Every other 8 bytes are lost. Writing to EEPROM works, but, as expected, validation fails as what is written does…
-
A couple of issues that I've found whilst trying to install the sketch and libraries:
1. It would probably be better to put the `babuino/babuino.ino` sketch in a directory called `examples` in the …
-
I have installed 1.6.7, Arduino IDE 1.8.10, Arduino core 1.8.1
#include
https://github.com/digistump/DigistumpArduino/issues/34#issue-154927992
-
I've been trying to use the DS1682 as pulse counter and would like to reset the counter every now and then.
Calling resetElapsedTime() and resetEvents() only resets the counter until the next pulse c…
linwp updated
6 years ago
-
For STM32F103C8 device the FLASH_BASE_ADDRESS in libraries/EEPROM/src/utility/stm32_eeprom.c is calculated as (line 84):
```
((uint32_t)((FLASH_END + 1) - FLASH_PAGE_SIZE))
```
where FLASH_END is …
-
As it turns out the fs.com's xgspon cannot update it's gpon_sn, the command described in the guide will only actually change the login to the device, to actually alter the gpon_sn that is used the in …