-
On a Dell Venue 8 Pro 5830, Linux 6.8 with Clang and LTO triggers a BUG() and the rt5640 audio driver to fail. This happens with the older driver and with the newer SOF driver forced with `snd-intel-d…
-
I've had my NanoKVM plugged into my macbook for testing but I never get any stream output in the webui.
If I manually run ` /kvmapp/kvm_stream/kvm_stream` I get a few errors, but these are the log…
-
I get this error when I unload modules intel_ipu6_isys and ov2740, then run systemctl suspend and then try to modprobe intel_ipu6_isys back. Without suspend everything works fine and camera works prop…
-
Thank you very much for your work on this!
I thought I'd add a note regarding decoding the status bits, both from a general knowledge and safety perspective.
In a simple 5800 installation with o…
-
The paragraph above figure 15 in section 6 (and figure 15 as well) describes an endpoint as having zero or more hardware components and zero or more software components, where each may have zero or mo…
-
With many types of sensors and parameters it would be ideal if one could run a query per pin (and its popup).
But there is obviously also huge advantage of having a single query for a whole GIS map/…
-
I'm not sure if this is possible, but I notice that my unit has a "follow_me" mode. This toggles between a sensor in an unknown location (maybe intake vent?) and the thermostat in the wall controller.…
-
Hi I have a laptop Dell XPS 9340 and on arch linux. I managed to install everything, but when trying to run this command
`sudo -E gst-launch-1.0 icamerasrc buffer-count=7 ! video/x-raw,format=NV12,…
-
From Glorious Defender on Discord
Act 1
The AI is awakened by the ship's sensors after it picked up faint creepy musical noises
Users can
1- ignore (ends the event)
2- Follow (act 2)
Act …
-
EBB SB2209 CAN V1.0 (RP2040) + Voron Tap, suddenly unable to get Klipper to trigger the z endstop. Tried shorting gpio21 directly to gnd and no change within Klipper. Also tried connecting to gpio22…