-
Hello :wave:
I am attempting to make some contributions to the project but I can't seem to get the install from source to work. I am building from the master branch via:
```bash
$ cd pyocd
$ …
-
Hi all,
I am getting a repeated issue when attempting to flash a blank LPC5526 using pyocd. It always results in a Memory Transfer Fault. This issue persists when using a custom DAP-Link programmer…
-
**Describe the bug**
Flashing of the ST Nucleo G071RB board cannot be done because you cannot enable the support of the board on pyocd by adding “pack” support - stm32g071rb is probably missing in th…
-
`scons program` should be renamed to `scons upload` and support a more generic way to upload firmware to the device (preferrably only wrapped by SCons so it can be reused by CMake).
openocd != ST-L…
-
Run command "pyocd list", error occurred, pyocd version >= 0.30:
Successfully installed pyocd-0.30.0
```
PS C:\Users\wuze> pyocd list
0000671:WARNING:common:STLink and CMSIS-DAPv2 probes are not…
-
Pypemicro repeatedly outputs the same log message when opening the PEMicro library. This is annoying for pyocd users when it is polling for devices.
The request is that pypemicro track that it has …
-
### Description of defect
Mbed does something to the debug interface that prevents common debugger to connect normally to board.
Only `connect under reset` works, and the debugger session …
-
Hello world :-)
New version of pyOCD depends on https://github.com/aquynh/capstone but I have problem building it on my FreeBSD boxes. Is there any way to simply skip this part so I could have flas…
-
Hi,
I am looking for a tutorial on how to debug firmware by putting breakpoints in Visual Studio Code and USB interface (connected with the BTT SKR 1.4 Turbo).
How to setup? What all packages ar…
-
I have a brand new reel-board from Phytec, but apparently I can't manage to flash it. The problem is simple to reproduce on a clean installation of zephyr on Ubuntu 20.10 (groovy). I can flash no issu…
kydos updated
3 years ago